Contact Us

Tel:+86-592-5782488

Fax:+86-592-5664223

Mob:+8615606003688

E-mail: tjd@xmyuzhou.com

Add: No.318. South Tongji Road, Jimei District, Xiamen City, Fujian, China

Home > Industry > Content
introduction of power relay Nov 14, 2018

A power relay is a device that can make a transition in one or more electrical output circuits when the input (or excitation) meets certain specified conditions. It can be used in a neutral point direct grounding system as a directional component for zero sequence current protection.


Home appliances such as air conditioners often use power relays, and the more common ones are OMRON's G4A and Panasonic's JM. The more failure modes that occur with these types of relays are contact bonding.


The action process of the contact can be divided into two parts: contact closure and contact disconnection, that is, the process of the pull-in and release of the relay, which are cyclically switched at a certain frequency to form a contact opening and closing phenomenon. During the closing and opening of the contacts, there are many special physical and chemical phenomena, such as contact contact resistance, contact jitter and arcing.

Principle of action when the contacts are closed

When the moving contact and the static contact of the relay are in contact with each other, the contact rebound occurs, that is, the uncontrolled gap opening and closing, and the Joule heat generated by the arc and the energizing current at this time greatly affects the relay. The ability to open and close.

Principle of action when the contact is broken

When the contact is opened and the load is cut off, a dazzling spark and arc are generated, and the arc occurs until the arc voltage drops below the minimum arc voltage value, which causes a large damage to the contacts. Different contact materials and contact gap sizes directly affect the radiation state of the arc electrons and the easiness of the arc electrons, so they are important conditions for determining the arc.


Previous: No Information

Next: No Information